DesignOCS has no dog in the fight. You are in control whether you use our consulting efforts to your advantage or not. We are in business to save you time and money, enabling you able to maintain a bigger bottom line. We are not in the business to tell you where to send your parts. We will aid in that if asked to, and at times it is necessary. But that’s not the nature of the service DesignOCS has to offer. There isn’t any need to switch from your fabrication service at all in order to save money on your parts! Here are just a few other reasons why you will find value in doing business with us. Prototypes No matter how large or small, a prototype is what it is. The first time getting anything done is costly. That’s just common knowledge. But that said, there are still ways to chop down the cost involved with prototype fabrication. Yes, starting from the first run prototype there is money to be saved. Assemblies There are two different avenues that can be taken advantage of here. Details that involve each and every individual part, and the details that involve the assembly as a whole. The more parts per assembly, the bigger the savings can be! Production Run Jobs Here is where this service will pay off in abundance! Say your prototype is successful and is released for production. What you will have saved from the first part, will carry on and repeat itself over and over again, whenever fabricated! In the least of circumstances, if I can get your prototype only $15.00 cheaper, what’s that number turn into with quantities of 20, 50, 100, and so on? What about repeating production jobs that you have fabricated? We can help you with these too. Thousands of dollars are right there for your company to add back into it’s bottom line! There’s no difference if your parts are manufactured in-house or through a fabrication service, saving is saving. Why wait? Let us tell you why DesignOCS... DesignOCS        Design Optimization Consulting Services     603-975-0054